top of page
Atomic Metal Conditioner Maximum Diesel Truck for Power Steering Booster

Atomic Metal Conditioner Maximum Diesel Truck for Power Steering Booster

SKU: XA 42016
$98.00Price

The compound is designed for revitalization – repair, restoration, antiwear protection and increase of service life of power steering booster and other hydraulic equipment parts, improvement of lubricating properties of hydraulic fluid.

Special two-component formula of the compound allows to achieve the effect of simultaneous restoration of worn-out parts, their protection against wear and enhancement of lubricating properties of hydraulic fluid.

  • Effects

    • Restores operating surfaces of parts and compensates their current wear
    • Decreases steering force
    • Eliminates pump howl caused by wear
    • Increase pumping capacity
    • Decrease noise and vibration of the hydraulic system pump
    • Improves lubricating properties of hydraulic fluid and tribilogical characteristics of couplongs
    • Increase operating precision of the hydraulic steering booster within 30-60 miles after application
    • Protects parts against wear by low level of hydraulic fluid
  • Application

    Introduce the content of the syringe* into the fluid, which is warmed up to the operating temperature, in the tank of a power steering booster. Start the engine and provide its idle operation during 2-3 minutes. Then turn the steering wheel during 5 minutes with the engine turned on. Drive a car as you normally do. The treatment is considered complete after the mechanism has been in operation for 50 hours or after 950 miles of run.

    • The temperature of the compound before application should not be lower than +20…+25 0C.
    • It is recommended to preliminary dissolve the content of the syringe in a small amount (about 50ml) of used hydraulic fluid.
    • If the fluid in the tank of a power steering pump is contaminated (opaque or changed its initial color etc.) it’s recommended to change hydraulic fluid before application.
  • Dosage

    30 ml of the product is enough for hydraulic system with capacity of 3-5 l. If hydraulic fluid exceeds 5 liters dosage should be increased at the rate of 30 ml for every 5 l of oil.

  • Pakage

    Syringe 30 ml

Product Reviews

average rating is 3 out of 5, based on 150 votes, Product ratings

% Recommended

Thank you for writing a review

Write a Review

Load More

Related Products

bottom of page